2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 378Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 378

NOTE: If the meter reads resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
tester lead to the yellowgreen wire3With the starter button depressed, the meter must show 0.5-0.7 DC volts4With the starter
button released, the meter must show DC volts5Connect the red tester lead to the yellowgreen wire; then connect the black
tester lead to the orangewhite wire6With the starter button depressed, the meter must show DC voltsNOTE: If the meter does
not show as specified, replace the switchcomponent, connector, or switch harness Front Drive Selector Switch The connector
is the two-wire black snap-lock one in front of the steering postTo access the connector, the cover must be removedNOTE:
Resistance tests should be made with the connector disconnected and on the selector-side of the connector RESISTANCE (Emergency
Stop) RESISTANCE 1Set the meter selector to the OHMS position2Connect the red tester lead to the orange wire; then connect
the black tester lead to the orangewhite wire3With the switch in the OFF position, the meter must show an open circuit4With