2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 379Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 379

2Connect the black tester lead to the negative battery terminal3Connect the red tester lead to the red wire on the harness
tester lead to the switch terminal (leaving the wire connected) and the black tester lead to ground VOLTAGE 1Select the 2WD
position on the front drive selector switch; then disconnect the connector on the actuator wiring harness2With the ignition
switch in the OFF position, connect the black tester lead to the black wire in the supply harness; then connect the red tester
lead to the orange wire in the supply harness3Turn the ignition switch to the ON positionThe meter must show 12 DC volts4Connect
the red tester lead to the whitered wire in the supply harnessThe meter must show 12 DC volts5Select the 4WD position on
the front drive selector switch; then connect the red tester lead to the whitered wire in the supply harnessThe meter must
show DC voltsNOTE: The 4WD icon on the LCD should illuminate 2Turn the ignition switch to the ON positionThe meter must show