2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 382Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 382

NOTE: Test the connector that comes from the engine 3The meter reading must be within specificationRESISTANCE (Crankshaft
more than 10 seconds Crankshaft Position Sensor 1Set the meter selector to the DC Voltage position2Connect the red tester
lead to the blue wire; then connect the black tester lead to the white wire3Crank the engine over using the electric starter4The
meter reading must be within specification NOTE: If both stator coil tests failed, check all connections, etc and test againIf
no voltage is present, replace the stator assembly RESISTANCE (Charging Coil) ! CAUTION Always disconnect the battery when
performing resistance tests to avoid damaging the multimeter Starter Motor REMOVINGDISASSEMBLING 1Set the meter selector
to OHMS position2Test between the three yellow wires for total of three tests1Disconnect the battery ! CAUTION Always disconnect
the negative battery cable from the battery first; then disconnect the positive cable 2Remove the nut securing the positive