2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 387Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 387

NOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect battery voltage (at
is defective, it must be replaced The CDI is rarely the cause for electrical problems; however, if the CDI is suspected,
substitute another CDI unit to verify the suspected one is defectiveKX206A NOTE: Make sure that the ignition switch is in
the ON position, transmission in neutral, brake lock released, and the emergency stop switch in the RUN position NOTE: Prior
to replacing the CDI unit to assure the CDI unit is defective, it is advisable to perform CDI peak voltage test (see Ignition
Coils in this section) andor perform continuity test of the wiring harness from the CDI connector to the CDI unit 3Depress
the starter button while observing the multimeterThe multimeter should drop to volts and "click" should be heard from the
relayNOTE: If "click" is heard and any voltage is indicated by the multimeter, replace the starter relayIf no "click" is
heard and the multimeter continues to indicate battery voltage, proceed to step 4 Electronic Control Unit (ECU) The electronic