2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 390Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 390

ECU Error Code List EC00 EC12 EC13 EC14 EC15 EC20 EC21 EC23 EC24 EC32 EC40 EC41 EC99======No Fault Detected CKP (Crankshaft
are made, install the Diagnostic Harness (pn 0486-219) by connecting it to the diagnostic plug; then turn the ignition switch
to the ON positionAfter three seconds, turn the ignition switch to the OFF position and disconnect the diagnostic harnessWhen
the ignition switch is turned on, the error code should not be displayed Tilt Sensor ! WARNING Incorrect installation of
the tilt sensor could cause sudden loss of engine power which could result in loss of vehicle control resulting in injury
or death OUTPUT VOLTAGE NOTE: Needle adapters will be required on the multimeter leads as the following tests are made with
the sensor connected ! CAUTION Do not drop the tilt sensor as shock can damage the internal mechanism SUPPLY VOLTAGE 1Connect
the three-wire plug to the sensor; then remove the right-side mounting screw securing the sensor to the rear frame 1Disconnect
the three-wire connector from the sensor; then select DC Voltage on the multimeter and connect the red tester lead to the