2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 391Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 391

2Install the needle adapters to the multimeter leads; then select DC Voltage on the multimeter3Connect the red tester lead
meter should read 4.0-8.0 DC volts after approximately one second in the tilted positionIf the meter readings are not as
specified, the tilt sensor is defective NOTE: Prior to testing the TPS, inspect the three-wire plug connector on the main
harness and the three-pin plug on the TPS for contamination, broken pins, andor corrosion 2Make sure the ignition switch
is in the OFF position; then select the DC Voltage position on the meter3Connect the black tester lead to spade terminal