2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 392Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 392

4Remove the red tester lead from spade terminal and connect it to spade terminal BThe meter should read 4.5-5.5 DC voltsNOTE:
the multimeter 6Select the OHMS position on the meter; then perform the following resistance tests on the TPSAPin (B) to
groundinfinity (open circuit)BPin (A) to pin (B)approximately 1.22k ohms (throttle closed)CPin (A) to pin (B)approximately
4.36k ohms (throttle full-open)DPin (A) to pin (C)approximately 4.05k ohmsFI451A 9Select the DC Voltage position on the meter
and turn the ignition switch to the ON positionThe meter should read approximately 1.12 DC volts with the throttle closed
and approximately 4.32 DC volts with the throttle in the full-open positionNOTE: If the meter readings are as specified,
check the main harness connector at the ECU main harness wiringIf the meter readings are not as specified, replace the TPS
and adjust to specifications (see INSTALLINGADJUSTING in this sub-section ! CAUTION Always make sure the ignition switch