2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 396Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 396

Front Drive Actuator NOTE: The actuator is not serviceable componentIf it is defective, it must be replacedNOTE: The actuator
no sound is heard, see Section 5If the actuator runs constantly or makes squealing or grinding sounds, the actuator must
be replacedREMOVING INSTALLING 1Remove the left-front inner fender panel; then disconnect the connector on the actuator harness2Using
T-30 torx wrench, remove the mounting cap screw from the driveshaft side of the actuator 1Lubricate the O-ring on the actuator;
then ensure that all mounting surfaces are clean and free of debris2Align the actuator with the selector shaft and slide
it forward onto the shaft taking care to engage the cap screw in the slot of the front mounting tab 3Remove the mounting