2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 402Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 402

4On the 400500650 H1, install the input shaft into the housing; then install the front boot and secure with Boot Clamp (pn
and spring 2Using T-40 torx wrench, remove the cap screws securing the gear case coverAccount for and make note of the ID
tag location for assembling purposes 5Place the pinion housing with new gasket onto the gear case housing; then secure with
the existing cap screwsTighten to specificationsNOTE: If new gear case housing is being installed, tighten the cap screws