2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 404Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 404

NOTE: On front differential, the lock collar has right-hand threadsOn rear gear case, the lock collar has left-hand threads
proceed to the following Shimming ProcedureShim Selection sub-section Shimming ProcedureShim Selection 8Using the Pinion
GearShaft Removal Tool (pn 0444-127) and hammer, remove the pinion gear from the gear case housing 1Press bearings into bores
by outer ring to hard contact with seat2Install the lock collar and tighten to specifications; then on final assembling,
stake the lock collar edge approximately 1.5 mm (0.060 in into the lower oil channel 9Secure the pinion gear in bearing puller;