2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 407Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 407

11Making sure the O-ring is properly positioned on the gear case housing, install the housing with existing hardwareAccount
This procedure can be performed on rear gear case 9Install the left bearing housing aligning the match mark to the mark on
the differential housing 1Place 6.35 mm (14 in drill bit on the inside surface of the needle bearing (against the bottom
side); then drill through the pinion shaft needle bearing housing 10Install the differential lock assembly into the bearing
housing; then place the O-ring on the gear case housing 2Using propane torch, heat the area surrounding the needle bearing