2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 411Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 411

Drive Axles REMOVING REAR DRIVE AXLE 8While holding the drive axle stationary, pull the top of the knuckle out and down until
axle components to determine if any service or replacement is necessary 1Using clean towel, wipe away any oil or grease from
the axle componentsKX041 5Remove the two brake calipers (right side only)NOTE: Do not allow the brake calipers to hang from
their cablehose ! CAUTION The calipers should be supportedIf the calipers are allowed to hang from the cablehose, damage
may occur 6Slide the hub out of the knuckle and set aside7Remove the cap screw and lock nut securing the knuckle to the upper
A-armDiscard the lock nutNOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut