2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 414Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 414

7Slide the boot over the housing; then using the boot clamp pliers, secure the boot with the clamp CD022 ! CAUTION The bearing
specifications3Place the hub into position on the axle followed by hex nutTighten the hex nut finger-tight at this time4If
the brake calipers were removed, position them on the knuckle and secure with existing cap screwsTighten the auxiliary brake
caliper cap screws to specificationsTighten the hydraulic brake caliper cap screws to specifications5Pump up the hand brake
lever; then engage the brake lever lock6Tighten the hub hex nut (from step 3) to specifications; then install and spread
new cotter pin making sure each side of the pin is flush to the hub nut 6Making sure the marks made during disassembling
align, slide the housing over the bearing ring; then completely seat the bearing ring into the housing and install the circlipNOTE: