2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 416Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 416

AT THIS POINT For servicing the input shaft, pinion gear, needle bearing, and axle seal, see Front Differential in this
the hub assembly6Remove the four cap screws securing the brake discCLEANING AND INSPECTING NOTE: Whenever part is worn excessively,
cracked, or damaged in any way, replacement is necessary REMOVING 1Clean all hub components2Inspect all threads for stripping
or damage3Inspect the brake disc for cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearINSTALLING
1Secure the ATV on support stand to elevate the wheel; then remove the wheel ! WARNING Make sure the ATV is solidly supported
on the support stand to avoid injury 1Secure the brake disc to the hub with the four cap screws coated with blue Loctite
#243Tighten to specifications2Apply grease to the splines in the hub 2Remove the cotter pin from the nutNOTE: During assembly,