2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 429Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 429

7Inspect the handlebar tube for cracks, wear, or unusual bends8Inspect the handlebar grips for damage or wearINSTALLING 1Place
or damaged in any way, replacement is necessary 1Wash the tie rod ends in parts-cleaning solventDry with compressed airInspect
the pivot area for wearApply low-temperature grease to the ends ! WARNING Always wear safety glasses when using compressed
air 3Install the tie rods and secure with the slotted nutsTighten to specifications; then install new cotter pinsNOTE: If
the slots do not align with the holes in the tie rod ends, tighten the nuts just enough to allow installation of the cotter
pins 2Inspect the tie rods for damaged threads or wear3Inspect the tie rods for cracks or unusual bends4Inspect all welded