2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 431Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 431

INSTALLING NOTE: Before installing grip, use contact spray or alcohol to clean the inside of the grip and the handlebar of
is allowed to fall, it will be damaged and will have to be replaced ! WARNING Make sure the ATV is solidly supported on the
support stand to avoid injury CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any
way, replacement is necessary 2Remove the wheel cap from the hub; then remove the cotter pin from the nut3Remove the nut
securing the hub4Remove the brake caliper5Remove the hub assembly6Remove the cotter pin from the tie rod end and remove the
tie rod end from the knuckle7Remove the two cap screws securing the ball joints in the knuckle8Tap the ball joint end out
of the knuckle; then remove the knuckle9Remove the snap ring from the knuckle; then remove the bearing 1Clean all knuckle