2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 435Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 435

3Remove the front rack from the ATVCLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in
to the body; then remove the storage compartment and the steering post cover Front Bumper Assembly REMOVING 1Remove the two
flange bolts and lock nuts securing the upper bumper supports to the bumper2Remove the through-bolt and lock nut securing
the bumper to the frame; then remove the bumperCLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked,
or damaged in any way, replacement is necessary 1Clean all bumper components with parts-cleaning solvent2Inspect all welds
for cracking or bendingINSTALLING 1Place the front bumper assembly into position and install the through-boltStart the lock
nut and finger-tighten only2Install the two flange bolts and lock nuts on the upper supportsTighten all hardware securely8-10
4Remove the left-side and right-side fender splash panels; then remove one press-in fastener and one reinstallable rivet
from the left side and right side of the air-intake splash shroudDo not remove the shroud5Disconnect the four headlight connectors