2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 453Get this manual

2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 453

Gearshift Pedal (Manual Transmission) ! CAUTION Do not attempt to either engage or disengage the front differential while
Drive Selector The automatic drive selector allows the operator to operate in either 2-wheel drive (rear wheels) or 4-wheel
drive (all wheels)For normal riding on flat, dry, hard surfaces, 2-wheel drive should be sufficientIn situations of aggressive
trail conditions, 4-wheel drive would be the desired choiceTo either engage or disengage the front wheels, move the switch
to the 4WD position or to the 2WD position To adjust the differential lock cable, see Section 2 Shift Lever REMOVING 1Remove
the E-clip securing the shift rod to the engine shift arm2Remove two cap screws, two self-tapping screws, and three nylon
ties securing the left-side splash panel and remove the panel3Remove the axle and nut securing the shift lever to the upper
shift arm; then remove the shift leverAccount for spring and two O-rings4Using two open-end wrenches, remove the lock nut