2007 Arctic Cat ATVs factory service and repair manual, Page 11Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 11

Either drain the gas tank or add Fuel Stabilizer to the gas in the as tankRemove the air filter housing cover an air filterStart
cables On carbureted models, drain the carburetor float chamberPlug the exhaust hole in the exhaust system with clean clothApply
li ht oil to the upper steerin post bushing and ungers of the shock absor ers Tighten all nuts, bolts, cap screws, and screwsMake
sure rivets holding components together are tightRe lace all loose rivetsCare must be taken that calibrated nuts, cap screws,
and bolts are tightened to specifications (see Section 10) On liquid cooled models, fill the cooling system to the bottom
of the stand pi in the radiator neck with properly mixed coo ant A CAUTION The ignition switch must be in the OFF position
prior to installing the battery or damage may occur to the ignition system Disconnect the battery cables; then remove the
battery, clean the battery posts and cables, and store in clean, dry areaStore the ATV indoors in level position A CAUTION