2007 Arctic Cat ATVs factory service and repair manual, Page 14Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 14

Lubrication Points It is advisable to lubricate certain components periodically to ensure free movementApply light oil to
necessary; then install vent plugs A CAUTION Before installing the battery, make sure the ignition switch is in the OFF position
Battery acid is harmful if it contacts eyes, skin, or clothingCare must be taken whenever handling battery Place the battery
into position in the ATV and secure with the hold-down bracketAttach the vent tube and check the vent tube to make sure it
is not crimped or obstructed in any way and that it is properly routed through and secured to the frameConnect cables to
the proper terminals: positive cable to the positive terminal (+) and negative cable to the negative terminal (-)Connect
the negative cable last If the battery is discharged, remove the battery from the ATV and charge the battery at 1.5 amps
for 10 hoursTo remove and charge the battery, use the following procedure Anytime service is performed on battery, the following