2007 Arctic Cat ATVs factory service and repair manual, Page 20Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 20

13Install the valve timing inspection plug and tighten securely; then install the recoil starter assembly and secure with
spark plug; then attach the high tension lead to the plug and ground the plug on the cylinder head well away from the spark
plug holeInstall the tappet on the appropriate valve; then install the camshaftUsing an appropriate bar, rotate the engine
through two full revolutions; then rotate to TDC on the compression stroke and check the valve tappet clearance1NOTE: Rotating
the engine ensures that any excess oil is squeezed from the tappets and tappet shimsOil trapped in these areas could result
in false valve clearance reading A CAUTION On the 700 EFI, do not ground the spark plug on the cylinder head coverThe cover
is made of magnesium and any contact with spark or electrical arc will severely pit the surface 4Attach the Compression Tester
Kit 0444-213) 1NOTE: The engine must be warm and the battery must be fully charged for this test 5While holding the throttle
lever in the full-open position, crank the engine over with the electric starter until the gauge shows peak reading (five