2007 Arctic Cat ATVs factory service and repair manual, Page 23Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 23

EngineTransmission Oil Filter Strainer OIL= 4On the 4001500, remove the oil filter plug from the filter mounting boss (located
plug and tighten to specificationsPour the specified amount of the recommended oil in the filler holeInstall the oil level
sticklfiller plug A CAUTIONAutomatic Transmission Any oil used in place of the recommended oil could cause serious engine
damageDo not use oils which contain graphite or molybdenum additivesThese oils can adversely affect clutch operationAlso,
no1 recommended are racing, vegetable, non-detergent, and castor-based oils 9Start the en ine (while the ATV is outside on
level ground and allow it to idle for few minutes 10Turn the engine off and wait approximately one minute0735-505 3Remove
the drain plug from the bottom of the engine and drain the oil into drain pan 11Unscrew the oil level stick and wipe it with
clean cloth12Install the oil level stick until the threads touch engine caseH NOTE: The oil level stick should not be threaded