2007 Arctic Cat ATVs factory service and repair manual, Page 28Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 28

6Observe each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below
surface (wall or similar aiming surface)1 NOTE: There should be an average operating load on the ATV when adjusting the headlight
aim Switches Each time the ATV is used, switches should be checked for proper operationUse the following list for referenceAIgnition
switchengine will startBEmergency stop switchengine will stop 2Measure the distance from the floor to the mid-point of each
headlight3Using the measurements obtained in step 2, make horizontal marks on the aiming surface CReverse switchreverse indicator
light will illuminateDHiILo switchheadlight beam bright and dim 4Make vertical marks which intersect the horizontal marks