2007 Arctic Cat ATVs factory service and repair manual, Page 31Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 31

Hydraulic Brake Systems CRemove the protective cap, install one end of clear hose onto one FRONT bleeder screw, and direct
reservoir sight glass very closely to make sure there is always sufficient amount of brake fluidWhen the sight glass changes
from dark to light, refill the reservoir before the bleeding procedure is continuedFailure to maintain sufficient amount
of fluid in the reservoir will result in air in the system DRepeat step until the brake lever is firmEAt this point, perform
step B, C, and on the other FRONT bleeder screw; then move to the REAR bleeder screw and follow the same procedure4Carefully
check the entire hydraulic brake system that all hose connections are tight, the bleed screws are tight, the protective caps
are installed, and no leakage is present 3To bleed the brake system, use the following procedureARemove the cover and fill