2007 Arctic Cat ATVs factory service and repair manual, Page 34Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 34

INSTALLING H NOTE: At this point, the wedge can be removed from between the driven clutch faces 1Spread the faces of the
secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten the cap screws
to specifications (see Section 10) 2Place the V-belt into position on the driven clutch and over the front shaftW NOTE: Make
sure the main engine ground wire is installed and secured in the proper location 6Secure the front fender to the footrest
with the two cap screwsTighten securely7Install the right-side footrest (see Section 8) W NOTE: The arrow on the V-belt should