2007 Arctic Cat ATVs factory service and repair manual, Page 53Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 53

6Using an awl, rotate the C-ring in its groove until it is out of the cylinder head; then remove the C-ring ICare should
the chain, slide the sprocket and camshaft out of the cylinder headAccount for an alignment pin 10Remove the cylinder head
from the cylinder, remove the gasket, and account for two alignment pins ILoop the chain over the cylinder and secure it
with wire to keep it from falling into the crankcase? AT THIS POINT 8Remove the cam chain tensioner by lifting it from the
chain cavity; then remove the two lower nuts securing the cylinder head to the cylinder, one in front and one in rear 11Remove