2007 Arctic Cat ATVs factory service and repair manual, Page 54Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 54

A CAUTION When removing the cylinder, be sure to support the piston to prevent damage to the crankcase and pis- 14Using an
pinsI NOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pln
0444-006) A CAUTION Do not allow the connecting rod to go down inside the crankcaseIf the rod is down inside the crankcase
and the crankshaft is rotated, severe damage will resultMD1214 B AT THIS POINT To service cylinder, see Servicing Top-Side
Components sub-section I NOTE: If the existing rings will not be replaced with new rings, note the location of each ring
for pro er installationWhen replacing with new rings, rep ace as complete set onlyIf the piston rings must be removed, remove
them in this sequence AStarting with the top ring, slide one end of the ring out of the ring-groove Arctic Cat ATV 2007 -All