2007 Arctic Cat ATVs factory service and repair manual, Page 55Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 55

BRemove each ring by working it toward the dome of the piston while rotating it out of the groove B AT THIS POINT To service
the cup B AT THIS POINT To service any one specific component, only limited disassembly of components may be necessaryNote
the AT THIS POINT information in each sub-section4Remove the gear shift stopper (located above the hillow shift shaft)Account
for the washer, spring, and stopper I NOTE: The enginetransmission does not have to be removed from the frame for this procedure
Removing Left-Side Components ACoverStator Assembly 1Remove the two cap screws securing the starter to the crankcase: then
remove the starter2Remove the four cap screws securing the recoil cover to the left-side cover; then remove recoil coverI