2007 Arctic Cat ATVs factory service and repair manual, Page 56Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 56

INOTE: To aid in installing, it is recommended that the assemblies are kept together and IN ORDER 5Remove the cap screws
rotorlflywheel assembly from the crankshaftAccount for the key; then remove the starter clutch gear assembly (H) wlwasherI
NOTE: Care must be taken that the remover is threaded all the way onto the rotorlflywheel INOTE: Inspect the inside of the
left-side cover for any shaft washers and spacers that may have come off with the coverMake sure they are returned to their
respective shaftsAlso, make sure the alignment pins are in place BRotorFlywheel CIdle Gear Assembly INOTE: Steps 1-5 in the
preceding sub-section must precede this procedureINOTE: For steps 6-14, refer to illustration Arctic Cat ATV 2007 -All Models