2007 Arctic Cat ATVs factory service and repair manual, Page 66Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 66

1 I B AT THIS POINT To service crankshaft assembly, see Servicing Center Crankcase Components sub-section Servicing Top-Side
in parts-cleaning solvent2Place the valve cover on the Surface Plate (pln 0644-016) covered with #400 grit wet-or-dry sandpaperUsing
light pressure, move the valve cover in figure eight motionInspect the sealing surface for any indication of high spotsA
high spot can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move the valve cover
in figure eight motion until uniform bright metallic finish is attained Table of Contents (Servicing Components) I NOTE:
Critical engineltransmission specifications are located at the beginning of this section A CAUTION Servicing Top-Side Components
3-29 Valve Assembly 3-29 Piston Assembly 3-32 CylinderICylinder Head Assembly 3-34 Servicing Left-Side Components 3-37 Recoil
Starter 3-37 Measuring Shift Fork (Thickness) 3-40 Measuring Shift Fork Groove (Width) 3-41 Measuring Shift Fork To Groove