2007 Arctic Cat ATVs factory service and repair manual, Page 70Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 70

H NOTE: If the existing rings will not be replaced with new ones, note the location of each ring for proper installationWhen
accu racy Measuring Piston-Ring End Gap (Installed) 1Place each piston ring in the wear portion of the cylinderUse the piston
to position each ring squarely in the cylinder 2Using feeler gauge, measure each piston-ring end gapAcceptable ring end gap
must be within specificationsATV-I 06' Measuring Piston Skirt1 Cylinder Clearance 1Measure the cylinder front to back in
six places Measuring Piston Pin (Outside Diameter) and Piston-Pin Bore 1Measure the piston pin outside diameter at each end
and in the centerIf measurement is not within specifications, the piston pin must be replaced 2Measure the corresponding