2007 Arctic Cat ATVs factory service and repair manual, Page 82Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 82

1If backlash measurement is less than specified, remove an existing shim, measure it, and install new thinner shim2If backlash
thin, even coat of machinist-layout dye to several teeth of the gear Correcting Tooth Contact 1 NOTE: If tooth contact pattern
is comparable to the correct pattern illustration, no correction is necessary 4Install the secondary driven output shaft
assembly 5Rotate the secondary driven bevel gear several revolutions in both directions If tooth contact pattern is comparable
to an incorrect pattern, correct tooth contact according to the following chartTooth Contact Shim Correction Contacts at
Top Contacts at Root 6Examine the tooth contact pattern in the dye and compare the pattern to the illustrations1 Incorrect
(contact at tooth top) 1 Decrease Shim ThicknessIncrease Shim Thickness 1 NOTE: To correct tooth contact, steps and (with
NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactIShim Correction" chart must be consulted A CAUTION