2007 Arctic Cat ATVs factory service and repair manual, Page 83Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 83

CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod
the indicator and push the small end of the connecting rod away from the dial indicator3Maximum deflection must not exceed
specificationsMeasuring Connecting Rod (Big End Side-to-Side) 2Mount dial indicator and base on the surface platePosition
the indicator contact at point of the crankshaft 1Push the lower end of the connecting rod to one side of the crankshaft
journal 2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal 3Zero the indicator and rotate
the crankshaft slowly A CAUTION Care should be taken to support the connecting rod when rotating the crankshaft 4Maximum
runout must not exceed specifications1 NOTE: Proceed to check runout on the other end of the crankshaft by positioning the