2007 Arctic Cat ATVs factory service and repair manual, Page 93Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 93

INOTE: The countershaft is now completely assembled for installation 3With the key in position, slide the driven gear onto
is installed To install the output shaft and gear, place the shaft into position with proper shims, slide the gear onto the
shaft, and secure with new nut tightened to specificationsApply liberal amount of engine oil to the crankshaft bearingUsing
propane torch, heat the bearing until the oil begins to smoke; then slide the crankshaft assembly into placeInstall the crank