2007 Arctic Cat ATVs factory service and repair manual, Page 95Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 95

9Install the two gear shift fork shafts; then verify that the two crankcase half alignment pins are in place1 NOTE: Prior
occurs 6From the right side, install the five case half mm cap screws (one inside the case); then tighten only until snugl
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 2Using plastic mallet, lightly tap the case
halves together until cap screws can be installed3From the right side, install the four case half mm cap screws; then tighten
only until snugtheback and forth to ensure no binding or sticking occurs.NOTE: 7In crisscrosscase-to-case pattern, tighten
the mm cap screws (from stem 3-4) until the halves are correctly joined; then tighten to specificationsI NOTE: Rotate the
shafts back and forth to ensure no binding or sticking occurs 8In crisscrosscase-to-case pattern, tighten the mm cap screws