2007 Arctic Cat ATVs factory service and repair manual, Page 96Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 96

I NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs A CAUTION 3Place the oil pump into position
the washer and pin into position on the oil pump shaft, install the oil pump driven gear, and secure with the circlipI NOTE:
Always use new circlip when installing the driven gear 2Place the strainer cap into position on the strainer making sure
the O-ring is properly installed and secure with the cap screws; then install and tighten the oil drain plug to specifications
5Place the gear shift cam plate and guide onto the gear shift cam making sure the alignment pin was installedSecure assembly