2007 Arctic Cat ATVs factory service and repair manual, Page 98Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 98

1 NOTE: After placing the primary clutch assembly onto the shaft, pull out on the pressure plate tower to ensure the pressure
Tighten the four roller assembly cap screws in crisscross pattern making sure there is no clearance between the clutch plates
when secured 13Place the primary drive one-way clutch into the centrifugal clutch housing noting the word OUTSIDE for proper
placement 16Install the clutch release arm and release roller guide making sure the release roller and guide are aligned
14Install the centrifugal clutch shoe and washer; then secure with the centrifugal clutch-shoe nut (left-hand threads)Tighten