2007 Arctic Cat ATVs factory service and repair manual, Page 102Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 102

13Install the two alignment pins into the left crankcase half l NOTE: Make sure that three washers and two alignment pins
and secure with the two cap screwsTighten securely Make sure the speedometer gear and output shaft gear match up during assembly
14Place the gasket and left-side cover into position on the crankcasel NOTE: It may be necessary to push or pull the splined
HiILow range shift shaft to establish coverlcrankcase mating 15Install the fifteen mm cap screws and one mm cap screw to
secure the left-side coverOnly finger-tighten at this time 18Place the starter cup into position on the crankshaft making