2007 Arctic Cat ATVs factory service and repair manual, Page 103Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 103

Installing Top-Side Components APiston BCylinder 19In crisscross pattern, tighten the cap screws (from step 15) to specifications
the expander making sure the expander ends do not overlapStagger the end gaps of the upper and lower thin oil rings according
to the illustrationl NOTE: Note the direction of the exhaust side of the piston (5) for correct ring end gap orientation
# Compression I Oil Ring Expander End Gap BInstall the compression rings (1 and 2) so the letter on the top surface of each
ring faces the dome of the pistonRotate the rings until the ring end gaps are on directly opposite sides of the piston (see