2007 Arctic Cat ATVs factory service and repair manual, Page 104Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 104

3Lubricate the inside wall of the cylinder; then using ring compressor or the fingers, compress the rings and slide the cylinder
the piston on the connecting rod making sure there is circlip on each side and the open end of the circlip is directed upwards
or downwards1NOTE: The piston should be installed so the arrow points toward the exhaust 4Loosely install the two nuts with
washers which secure the right-side of the cylinder to the right-side crankcase half1NOTE: The two cylinder-to-crankcase
nuts will be tightened in step 2Place the two alignment pins into positionPlace the cylinder gasket into position; then place