2007 Arctic Cat ATVs factory service and repair manual, Page 105Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 105

CCylinder Head DValve Cover 6Place the head gasket into position on the cylinderPlace the alignment pins into position; then
Cap Screw Plug 0-Ring Insulator Screw Intake Manifold i NOTE: Steps 1-4 in the preceding sub-section must precede this procedure
5While keeping tension on the cam chain, place the chain guide into the cylinder A CAUTION Care should be taken that the
bottom of the chain guide is secured in the crankcase boss 7Install the four cylinder head cap screws with washersNote that
the two cap screws on the right side of the cylinder head nearest the cam sprocket are longer than the two cap screws on