2007 Arctic Cat ATVs factory service and repair manual, Page 111Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 111

11Install the coil and connect the two wires; then install the high tension lead on the spark plug12Install the carburetor
sensor lead to the wiring harness 15Place the reversehighlow shift linkage wlbushing and washer onto the engine shift shaft
and secure with the E-clip18Install the exhaust pipe and secure with two cap screws; then install the muffler onto the frame
brackets and secure with exhaust springs 16Place the gear shift lever into position on the shaft on the engine; then secure