2007 Arctic Cat ATVs factory service and repair manual, Page 113Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 113

Table of Contents (400 Automatic Transmission) 2Remove the negative cable from the battery; then remove the positive cableRemove
the engineltransmission Removing Engine Transmission Many service procedures can be performed without removing the engineltransmission
from the frameClosely observe the note introducing each sub-section for this important information View from Beneath 6Remove
the front and rear fender panels (see Section 8)7Disconnect the fuel hose (I), carburetor vent hose (2), and the fuel pump
vacuum hose (3) from the carburetor B AT THIS POINT If the technician's objective is to servicelreplace left-side cover oil
seals (3), front output joint oil seal (I), rear outputjoint oil seal (I), andlor the oil strainer (from beneath the engine1
transmission), the engineltransmission does not have to be removed from the frame Secure the ATV on support stand to elevate
the wheels Make sure the ATV is solidly supported on the sup Iport stand to avoid injury8Disconnect the crankcase vent hose