2007 Arctic Cat ATVs factory service and repair manual, Page 114Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 114

9Remove the clamps securing the cooling ducts to the V-belt housing 10Remove the cooling ducts from the V-belt cover 14Remove
securing the exhaust pipe to the engine; then remove the exhaust springs from the muffler at the juncture in front of the
muffler- 12Loosen the clamp securing the carburetor to the intake; then route the carburetor assembly up and away from the
engine13Remove the E-cli securing the shift rod to the engine shift arm; en allow the shift rod to hang by the pivot axle
bolt 16Remove the four cap screws securing the rear output shaft to the transmission; then push the shaft to the rear as