2007 Arctic Cat ATVs factory service and repair manual, Page 115Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 115

21Remove the spark plug wire from the spark plus22Remove the shift indicator connector from the main wiring harness23Remove
17Remove the positive cable from the starter motor and route it out of the way18Disconnect the speed sensor lead from the
wiring harness 19Disconnect the stator-to-rectifierlregulator connector20Remove the temperature sensor wires from the engine1
NOTE: There are two temperature sensors 25Slightly raise the front of the engine to disengage the front driveshaft from the