2007 Arctic Cat ATVs factory service and repair manual, Page 116Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 116

26Remove the engine from the left side by moving the engine forward while raising the engine in the rear and rotating the
remove the valve coverNote the orientation of the cylinder head plug and remove itNote the location of the two alignment
pins 1 NOTE: The engineltransmission does not have to removed from the frame for this procedure Removing Top-Side Components
AValve Cover BCylinder Head 1 NOTE: Remove the spark plug and timing inspection plug; then using the recoil starter, rotate
the crankshaft to top-dead-center of the compression stroke1 NOTE: Arctic Cat recommends the use of new gaskets, lock nuts,
and seals and lubricating all internal components when servicing the engineltransmission 1Remove the cap screws securing
the two tappet coversRemove the two tappet coversAccount for the O-ringsMDI354A 3Loosen the cap screw on the end of the cam