2007 Arctic Cat ATVs factory service and repair manual, Page 119Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 119

1 NOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install connecting rod holder A CAUTION
A CAUTION When removing the cylinder, be sure to support the piston to prevent damage to the crankcase and pisIton 14Using
an awl, remove one piston-pin circlipTake care not to drop it into the crankcase AStarting with the top ring, slide one end
of the ring out of the ring-groove BRemove each ring by working it toward the dome of the piston while rotating it out of
the groove15Using Piston Pin Puller (pln 0644-328), remove the piston pinAccount for the opposite-side circlipRemove the
piston1 NOTE: It is advisable to remove the opposite-side circlip prior to using the puller B AT THIS POINT To service piston,