2007 Arctic Cat ATVs factory service and repair manual, Page 121Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 121

I 1 NOTE: Inspect the inside of the left-side cover for any shaft washers that may have come off with the coverMake sure
(pln 0444-075), break the rotorlflywheel assembly loose from the crankshaftRemove the remover, the crankshaft protector,
the rotorlflywheel, and the starter clutch gearAccount for the key DRotorFlywheel EStarter Motor 1 NOTE: Steps 1-4 in the
preceding sub-section must precede this procedure 5Remove the rotorlflywheel nut 6Install the crankshaft protector 8Remove