2007 Arctic Cat ATVs factory service and repair manual, Page 130Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 130

Table of Contents (Servicing Components) 1 NOTE: Critical enginetransmission specifications are located at the beginning
continuing to move the valve cover in figure eight motion until uniform bright metallic finish is attained# A CAUTION Do
not remove an excessive amount of the sealing surface or damage to the camshaft will resultAlways check camshaft clearance
when resurfacing the valve cover Servicing Top-Side Components 1NOTE: Whenever part is worn excessively, cracked, or damaged
in any way, replacement is necessary A CAUTION Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry
sandpaper or damage to the sealing surface may result VALVE ASSEMBLY Removing Valves 1NOTE: Keep all valves and valve components
as setNote the original location of each valve set for use during installationReturn each valve set to its original location
during installation When servicing valve assembly, inspect valve seats, valve stems, valve faces, and valve stem ends for
pits, burn marks, or other signs of abnormal wear1NOTE: Whenever valve is out of tolerance, it must be replaced CleaningInspecting