2007 Arctic Cat ATVs factory service and repair manual, Page 140Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 140

9Remove the spiral spring from the case by lifting the spring end up and outHold the remainder of the spring with thumbs
rope for breaks or fraying6Inspect the spiral spring for cracks, crystallization, or abnormal bends 6Install the ratchet
onto its pin making sure the end is properly installed on the reel 7Inspect the handle for damage, cracks, or deterioration
1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting lug in the case;
then wind it in counterclockwise direction until the complete spring is installed1NOTE: The spiral spring must seat evenly
in the recoil case 7Install the shaft, spring, and the spring cover 2Insert the rope through the hole in the reel and tie
knot in the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the
reel 8Install the friction plate with the ratchet guide fitting into the ratchet Page: 140 Arctic Cat ATV 2007 -All Models